
FoamPro 1601
The FoamPro 1601 is an electronic, fully automatic, variable speed, direct injection and discharge side foam proportioning system for Class A foam. The system is accurate to within 3% of calibrated settings over the advertised operation range when installed. The control module is installed in the pump control panel. The module enables the operator to activate the foam proportioning system, select proportioning rates from 0.1% to 1.0%, see a "low concentrate" warning flash when the foam tank runs low and in two minutes, if foam is not added to the tank, will shut the foam pump off.
Minuteman Standard Features
-
Steel Body Construction
The custom built body is fabricated from heavy channel iron and premium sheet steel with welded seams. All structural components of the bed are steel to comply with SAE J1194 for the Fire Attack Operational Areas in the BATROPS crosswalk.
-
BATROPS Crosswalk
Directly aft of the chassis cab, the BATROPS (Blanchat Apparatus Transverse Roll-Over Protection System) is a transverse crosswalk which follows SAE International Surface Vehicle Standard #J1194 for roll-over protective structures.
-
Trans-length Compartments
Trans-length compartments are fabricated into each side of the steel structure. They run the length of the bed, directly behind the BATROPS crosswalk to the rear bumper. Depending on which type of Minuteman is chosen, the compartments will have either one or two swing-up doors.
-
Rear Access Compartment Storage
The incorporated side compartments have rear access to the top-most section for storage of shovels, pike poles, rescue braces, 12 foot extension ladders, backboards, etc. This storage area can be accessed on both sides via an aluminum tread plate flip-down door with quick release latches.
-
Top Hose Bed
A recessed top hose compartment above the tank is fitted with slatted, one inch pressure treated lumber to facilitate hose drying. The area extends from behind the pump panel to the rear of the bed.
-
Blanchat Restraint System
The Blanchat Restraint System is a 4-point full body harness which is attached within the BATROPS Fire Attack Operational Areas. It allows the firefighter to operate within the Fire Attack Operational Area from a seated or standing position.
-
Recessed Poly Tank
The tank is created by hand of polypropylene material that is several times stronger than standard propylene and features a lifetime warranty. The tank is recessed into the frame of the body for a low center of gravity.
-
Water Level Indicator
A tankvision water level indicator is installed on the left side of the pump panel.
-
Hale HPX200 Pump with Briggs 23 HP
The standard pump is a Hale HPX200 with Briggs & Stratton Vanguard 23 HP V-twin overhead valve engine. The pump performance is 200 GPM at 100 PSI and 300 GPM at 25 PSI. The pump has a hand priming system standard.
-
Pre-connected Crosslay
The 1-1/2 inch pre-connected crosslay hose bed is located behind the BATROPS crosswalk underneath the pump panel area. The hose bed is accessible from driver and passenger sides as well as from the BATROPS area.
Explore all features
Minuteman Options
-
Blanchat Restraint Body Harness
This option includes one additional body harness for the Blanchat Restraint System.
-
Wheel Chock Set
A set of two wheel chocks are mounted in the rear wheel wells.
-
5 lb Dry Chemical Fire Extinguisher
A 5 lb dry chemical fire extinguisher with 40-B:C is mounted on the bed for easy access.
-
First Aid Kit
A first aid kit is mounted in an easily accessible location.
-
35 HP Pump
The pump can be upgraded to a Hale HPX275 with Briggs & Stratton 35 HP V-twin overhead valve engine. The pump performance is 190 GPM at 145 PSI from draft to supply two 95 GPM nozzles with 200 feet of 1-3/4 inch hose or 250 GPM at 125 PSI from draft to supply two 125 GPM nozzles with the same size hose.
-
FoamPro 1601
The FoamPro 1601 is an electronic, fully automatic, variable speed, direct injection and discharge side foam proportioning system for Class A foam. The system is accurate to within 3% of calibrated settings over the advertised operation range when installed.
-
CAFS Accelerator Controller
The Blanchat Accelerator Controller CAF System has a compact design which allows for easy installation on almost any application. From wildland to structure fires, the equalizer system has many benefits including: simplicity, reliability, effectiveness, flexibility and a lifetime warranty.
-
Tankvision with Mini Slave
The main indicator is installed in the pump panel with a mini slave in the cab.
-
4 Light Water Level Indicator
Four LED tank status lights (green, blue, amber and red) provide bright, easy to identify indication of water status. The option also includes a mini slave.
-
Two Preconnected Whiplines in Crosswalk
The pump panel is plumbed for an additional whipline (yellow knobs) in the crosswalk.
Explore all options
Minuteman Overview
Standard Roll-Over Protection

The B-24 & B-27 Minuteman models (the only Minuteman models that have a crosswalk area) feature the BATROPS (Blanchat Apparatus Transverse Roll-Over Protection System) which follows Surface Vehicle Standard SAE J1194 for roll-over protective structures. This is the same standard used for agricultural tractors.
- Greg BlanchatNo other industry manufacturer features a Fire Attack Operational Area that follows SAE J1194 for roll-over protection.

Two Fire Attack Operational Areas are located directly behind the chassis cab which allow a firefighter to stand or sit during pump and roll up to 15 MPH. The center Pump Control Operational Area allows access to the top-mount pump panel. The Pump Control Operational Area does not follow SAE J1194 and should not be used while the apparatus is in motion.
Learn more about the BATROPS
Blanchat Restraint System
A four point body harness is standard which allows the firefighter full movement within the Fire Attack Operational Area but locks upon any sudden movement keeping the firefighter from being thrown.

Learn more about the Blanchat Restraint
39.2° Vehicle Stability Test


The B-27 Minuteman was tilt tested at the US Forest Service Technology & Development Center in San Dimas, CA. The unit was fully loaded with fuel, tools, 400 gallons (1514 liters) of water and a weight of 250 lbs (113 kg) in the driver and passenger seating positions. The chassis' 19,500 GVWR was maxed out using sandbags.
The B-27 Minuteman accomplished 39.2° on both sides.
The “95-Percent Solution”
The late Larry Davis of Fire Rescue magazine called the B-27 Minuteman the “95-Percent Solution” in May 2008.
- Larry Davis...it’s equipped to handle 95 percent of the incidents to which rural firefighters respond, and it serves as a quick-out vehicle that allows a two-person team to arrive on scene, perform size up, take some initial actions and advise incoming personnel as to what must be done.
Read more
Recently Delivered Units
Fort Hood Fire Dept.
Location: Fort Hood, TX 76544 USA
Model: B-24 Minuteman Xtreme Rescue Truck
Delivered: 2020-10-14
Wallace RFPD
Location: Wallace, NE 69169
Model: B-24 Minuteman Rescue Truck
Delivered: 2019-10-11
Idabel FD
Location: Idabel, OK 74745 USA
Model: B-27 Minuteman
Delivered: 2019-08-11
Fort Hood FD
Location: Fort Hood, TX 76544 USA
Model: B-24 Minuteman Xtreme Rescue Truck
Delivered: 2019-07-22
Pilot Knob FPD
Location: Pilot Knob, MO 63663 USA
Model: B-27 Minuteman Rescue Truck
Delivered: 2019-07-28
View more deliveries
Fort Hood Fire Dept.
{gallery}delivered/2024RX03{/gallery}
Location: Fort Hood, TX 76544 USA
Model: B-24 Minuteman Xtreme Rescue Truck
Delivered: 2020-10-14
Wallace RFPD
{gallery}delivered/1924R05{/gallery}
Location: Wallace, NE 69169
Model: B-24 Minuteman Rescue Truck
Delivered: 2019-10-11
Idabel FD
{gallery}delivered/1727R04{/gallery}
Location: Idabel, OK 74745 USA
Model: B-27 Minuteman
Delivered: 2019-08-11
Fort Hood FD
{gallery}delivered/1924RX13-FH{/gallery}
Location: Fort Hood, TX 76544 USA
Model: B-24 Minuteman Xtreme Rescue Truck
Delivered: 2019-07-22
Pilot Knob FPD
{gallery}delivered/1927R06{/gallery}
Location: Pilot Knob, MO 63663 USA
Model: B-27 Minuteman Rescue Truck
Delivered: 2019-07-28



























Blanchat Mfg., Inc.


